Automatic Burner Control Programmer with Ignition Electrode Assembly

About this part

Comprehensive burner management sequence controller designed to automate pre-purge, ignition spark generation, pilot/main flame establishment, continuous flame monitoring, and post-purge cycles on medium-to-large industrial steam boilers. Accompanied by heat-resistant ceramic insulated spark ignition electrodes for reliable arc ignition.

Key features

• Fully automated startup sequence with timed pre-purge air flushing for furnace explosion prevention
• High-voltage ceramic ignition electrode rods resistant up to 1200°C
• Lockout safety indicator with manual reset pushbutton
• Continuous flame signal checking with instant lockout during loss of flame
• Modular plug-in base wiring design for fast maintenance replacement

Typical applications and wear

Monoblock and duoblock gas/oil burners, asphalt plants, and steam boilers. Wear involves relay contact oxidation and electrode tip spark erosion.

Compliance

Available in configurations designed for EN 298, NFPA 85, or other applicable combustion-safety requirements; verify certification for the exact controller and installation.